SC Licensed | Fully Insured | SCGWA & NGWA MemberWest Columbia: (803) 926-5402  |  Newberry: (803) 926-7080
πŸ† Est. 1960πŸ‘¨β€πŸ‘©β€πŸ‘§β€πŸ‘¦ 4th Generation FamilyπŸ’§ 13,000+ Wells DrilledπŸ”§ 100% In-House Crews⭐ 4.8β˜… on Google

Most shallow well jet pump repair comes down to five parts: the pressure switch, shaft seal, impeller, foot valve or suction line. Some are cheap fixes. Some mean the pump is done. And sometimes the pump is fine and the water has dropped out of its reach.

Austin Drilling has worked on South Carolina wells since 1960. Here's how we sort a repair from a replacement.

What usually breaks on a shallow well jet pump?

The pressure switch is the usual suspect. It's the small gray box that turns the pump on and off. Contacts burn and the little tube feeding it clogs with sediment. A new switch is a quick repair, covered in our well pressure switch replacement page.

The shaft seal keeps water out of the motor. When it wears, you'll see a puddle under the pump. Catch it early and a seal fixes it. Let it go and water reaches the motor bearings.

Then there's the foot valve and suction line. A jet pump pulls water up, so any air leak breaks the suction. The pump runs and sends you nothing. That's a lost prime, explained in well pump losing prime.

Why would a jet pump run constantly?

A jet pump that never shuts off usually can't build pressure. The switch never hits its cutoff. Pentair ships its FN series shallow well pumps with the switch set at 30 to 50 psi. So if a pump like that tops out below 50, it just keeps running.

The usual causes are a worn impeller, a clogged jet, a suction leak or a dropped water level. Sand chews up impellers fast. Running dry ruins a pump. Shut it off at the breaker and call us.

How deep can a shallow well jet pump pull water?

About 25 feet. Pentair rates its FN series shallow well jet pumps at a 25-foot maximum lift. That's measured to the water level while the pump is running, not to the bottom of the well.

Why does that matter? Dry SC summers. Water levels drop, and a pump that worked for years starts losing prime every afternoon. No repair fixes that. You need a deep well jet pump or a submersible, and our well pump types page explains the difference.

When is a jet pump worth fixing, and when should you replace it?

Fix it when the motor is sound and the problem is a switch, seal, foot valve or fitting.

Replace it when the motor is burned, the housing is cracked, or water got into the bearings. Replace it when the water has dropped past what it can lift. And an old pump on its third major repair? Think hard.

We'll tell you which one you've got, with a clear price before we start. Every pump or tank we install carries a 5-year manufacturer's warranty, pump and tank only. Our Year 1 service guarantee covers new equipment, except acts of nature like lightning or freezing. Details are on our pump installation and repair service page.

What should you do before you call?

Stay safe. Note what the pressure gauge reads. Check whether the breaker tripped. Look for water under the pump. Don't open the pump or work on the wiring yourself.

One customer told us their pump ran after a storm, held about 45 psi, and still gave them no water. Another had a pump stolen off a 2-inch well and didn't know if the well was any good. We check the well first, so you don't buy a pump the well can't support. Storm outages are covered in well pump not working after a power outage.

Call Austin Drilling and we'll get your water back on. West Columbia is (803) 926-5402. Newberry is (803) 926-7080. We're open Monday through Friday, 7am to 6pm, and Saturday by appointment.

Frequently asked questions

Is shallow well jet pump repair cheaper than replacement?

Usually, when it's a switch, seal or foot valve. A burned motor or a cracked housing tips it toward replacement.

How long will a jet pump last once it starts leaking?

There's no safe number. A leaking shaft seal lets water reach the motor. Get it looked at soon.

Why is there no water pressure even though the pump is running?

The pump has likely lost prime, the impeller is worn, or the water level has dropped below its reach.

Do you do well jet pump repair near me in the Midlands and Upstate?

Yes. Austin Drilling handles shallow well jet pump repair across the SC Midlands and Upstate from West Columbia and Newberry.

Talk to a Real Well Company

66 years, 13,000+ wells, in-house crews across the SC Midlands and Upstate. Call Austin Drilling and we'll get your water right.

Related Reading

Well Problems? Give Us a Call.

We've been diagnosing and fixing SC wells since 1960. Call us or request your free water analysis β€” no obligation.